Remote Control Commands
R&S
®
SMA100B
496User Manual 1178.3834.02 ─ 05
Parameters:
<State> OFF | ON | HOLD
*RST: The preset value for each trace is evaluated during
runtime as follows: If a sensor is plugged into the
generator whose number corresponds to the trace
number, this sensor is used to feed the trace and
the state of the trace is ON; If no sensor is found
with a number corresponding to the trace number,
the preset value of the trace is "Off".
Example:
TRAC2:SWE:COPY REF
Stores trace2 as reference trace.
TRAC1:SWE:FEED REF
Assigns the reference trace to trace 1.
TRAC1:SWE:STAT ON
Assigns the reference trace to trace 1.
SENS:SWE:RMOD SING
Selects single measurement.
SENS:SWE:INIT
Starts the measurement.
Manual operation: See " Indication - Power Analysis " on page 227
:TRACe[:POWer]:SWEep:MEASurement:FULLscreen:DISPlay:ANNotation[:
STATe] <State>
Selects fullscreen display of the measurement diagram on the display and in the hard-
copy file.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Example:
TRAC:SWE:MEAS:FULL:DISP:ANN ON
The display only shows the diagram.
Options: Option R&S SMAB-K28
Manual operation: See "Full Screen" on page 253
:TRACe[:POWer]:SWEep:MEASurement:GATE:DISPlay:ANNotation[:STATe]
<State>
Activates th eindication of the time gate borders and values in the measurement dia-
gram and in the hardcopy file. The gate settings are performed with the
CALC:POW:SWE:TIME:GATE:… commands.
Parameters:
<State> 0 | 1 | OFF | ON
*RST: 1
Power Sensor Measurement Subsystems
To Next Page
Loading...
