Roland TrueVIS VG2-540 - Page 101

5. Adjust the misalignment of the ink landing posion.
Procedure
1. Press [◀] to select "SET".
MEDIA GAP ADJ.
[SET] NEXT
2. Press [ENTER] to conrm your entry.
Prinng of the test paern starts.
You can select "NEXT" and press [ENTER] to skip the current menu and proceed to the next menu.
3. Press [ENTER].
INPUT
ADJ. VALUES
4. View the printed test paern, and then determine the correcon value.
Select the value that gives the least misalignment between the two lines. In the case of the following gure,
select "-3." When you cannot choose between two sequenal numbers, select a value that is between them
(you can set correcon values in units of "0.5").
5. Press [▲] or [▼] to select the correcon value.
MEDIA GAP ADJ.
0 5
6. Press [ENTER] to conrm your entry.
7. Press [◀] to select "SET".
REDO ADJ.?
[YES] DONE
8. Press [ENTER] to conrm your entry.
The test paern is printed again. Check that the gap and overlap are the smallest for the gure indicated by
"
" (that is, the current correcon value). If the gap and overlap are smaller for another gure, return to
step 5 to perform the seng again.
If you do not need to change the correcon value, press [ENTER] again.
9. Press [▶] to select "DONE".
REDO ADJ.?
YES [DONE]
10. Press [ENTER] to conrm your entry.
Printing and Cutting Output
100 3. Printing and Cutting Method