Roland TrueVIS VG2-540 - Page 105

Check the media feed direcon (the feed direcon) and the direcon of print head movement (the scan
direcon).
8. Set the correcon values for the feed direcon "F" and the scan direcon "S."
(1) Press [▲] or [▼] to set the correcon value for the feed direcon (F).
F:+0.30 +0.35mm
S:-0.40 -0.45mm
(2) Press [◀] or [▶] to set the correcon value for the scan direcon (S).
F:+0.30 +0.35mm
S:-0.40 -0.45mm
(3) When you have nished seng the correcon values, press [ENTER].
The test paern (P&C1) is printed and cut again. Check the condion of the test paern to check
whether the prinng posion and the cung posion are aligned.
9. Determine whether to correct the misalignment.
• Cung posion and prinng posion are not aligned
Press [◀] to select "YES".
CONTINUE ADJ.?
[YES] DONE
• Cung posion and prinng posion are aligned
Press [▶] to select "DONE".
CONTINUE ADJ.?
YES [DONE]
10. Press [ENTER] to conrm your entry.
• If you select [YES], the test paern (P&C1) is printed and cut again. Go back to step 8 and perform the
seng again.
• If you select "DONE", proceed to the next procedure.
Printing and Cutting Output
104 3. Printing and Cutting Method