Roland TrueVIS VG2-540 - Page 106

8. Set the drying method and me aer prinng.
Procedure
1. Press [◀] or [▶] to select "NEXT".
CROP-CUT ADJ.
SET [NEXT]
2. Press [ENTER] to conrm your entry.
3. Press [▲] or [▼] to select [P&C].
Set whether the media should be fed unl the trailing edge of the printed area is put on the dryer aer the
1st page is printed. To enable this funcon only for output data designed for prinng and cung, select
"DISABLE". If "DISABLE" is selected, the trailing edge of the prinng area is not fed to the dryer unless you
connue with a subsequent prinng operaon.
FEED FOR DRY
DISABLE P&C
4. Press [ENTER] to conrm your entry.
5. Press [▲] or [▼] to set the drying me.
Set the drying me aer the 1st page is printed. The next operaon is not started unl the set me passes.
DRYING TIME
10min 10min
MEMO
This seng is enabled for output data designed only for prinng.
This seng is ignored for output data designed for prinng and cung. When the drying me has been set in the soware RIP,
priority is given to the soware RIP's seng.
Example of seng me (general guide)
The seng me varies according to the sengs such as the type of media and the prinng quality.
• Condion Non-coated vinyl chloride media
• Seng me: About three minutes
6. Press [ENTER] to conrm your entry.
7. Press [▲] or [▼] to set the drying me.
DRY TIME P&C
10min 10min
MEMO
This seng is enabled for output data designed for prinng and cung.
This seng is ignored for output data designed only for prinng. This seng is also applied during prinng and cung with
crop marks. Even if the drying me has been set in the included soware RIP, priority is given to the seng on this machine.
8. Press [ENTER] to conrm your entry.
Printing and Cutting Output
3. Printing and Cutting Method 105