Roland TrueVIS VG2-540 - Page 107

9. Save the sengs as a preset.
Procedure
1. Press [◀] to select "SAVE".
PRESET
[SAVE] NEXT
2. Press [ENTER] to conrm your entry.
If you select "NEXT" and press [ENTER], the screen in step 7 is displayed, and the sengs you have selected
up to this point are not saved as a preset. However, they will remain as the current seng values for the
machine.
3. Press [▲] or [▼] to select a desnaon to save the preset.
You can select a name from NAME1 to NAME8.
SAVE TO
NAME1
4. Press [ENTER] to conrm your entry.
5. Set the name.
(1) Press [▲] or [▼] to select a character.
(2) Press [▶] to move to the next character.
(3) Set the following characters in the same way.
You can enter up to15 characters.
SET NAME
6. Press [ENTER] to conrm your entry.
7. Press [MENU] to go back to the original screen.
COMPLETED
This completes the operaon of the "MEDIA SETTING" menu.
Printing and Cutting Output
106 3. Printing and Cutting Method