Roland TrueVIS VG2-540 - Page 38

3. Move the middle pinch rollers ( ) over all the remaining grit rollers covered by the media ( ).
There are grit paerns (
) wherever there are grit rollers.
MEMO
Place the middle pinch rollers over all the grit paerns within the media width. If you have forgoen to place the middle pinch
rollers, the media will be skewed during prinng or will come loose, which will have an eect on the prinng quality.
MEMO
• The middle pinch roller will not lower onto the three grit rollers from the right end. Place the middle pinch roller on a grit
roller other than these three.
• There may be extra middle pinch rollers depending on the width of the media being used. Move the extra middle pinch
rollers to posions where no grit paerns are present. Where no grit paerns are present, the middle pinch rollers will not
come down.
Setup of Media
2. Basic Operations 37