Roland TrueVIS VG2-540 - Page 47

MEMO
Press down on the bent part of the media clamps to li up both of their edges. Move the media clamps to the le and right
with both edges lied up.
7. Close the front cover.
The "PRESS ENTER TO PERFORM SETUP" message is displayed on the screen.
8. Press [ENTER].
When you press [ENTER], the cung carriage moves and detects the width of the media. This operaon is
called inializaon. When inializaon ends, [SETUP] on the operaon panel lights, and the printable width
is displayed on the screen. This completes the setup of the media.
Setup of Media
46 2. Basic Operations