Roland TrueVIS VG2-540 - Page 86

4. Save the sengs as a preset.
Procedure
1. Press [▶] to select "NEXT".
PRINT-CUT ADJ.
SET [NEXT]
2. Press [ENTER] to conrm your entry.
3. Press [▶] to select "NEXT".
CROP-CUT ADJ.
SET [NEXT]
4. Press [ENTER] to conrm your entry.
5. Press [ENTER] when the following screen appears.
These three sengs are ignored for output data designed only for cung. Press [ENTER] and proceed to the
next step.
FEED FOR DRY
DISABLE ENABLE
DRYING TIME
10min 10min
DRY TIME P&C
10min 10min
6. Press [◀] to select "SAVE".
PRESET
[SAVE] NEXT
7. Press [ENTER] to conrm your entry.
If you select "NEXT" and press [ENTER], the screen in step 12 is displayed, and the sengs you have selected
up to this point are not saved as a preset. However, they will remain as the current seng values for the
machine.
8. Press [▲] or [▼] to select a desnaon to save the preset.
You can select a name from NAME1 to NAME8.
SAVE TO
NAME1
9. Press [ENTER] to conrm your entry.
10. Set the name.
(1) Press [▲] or [▼] to select a character.
(2) Press [▶] to move to the next character.
(3) Set the following characters in the same way.
You can enter up to15 characters.
SET NAME
11. Press [ENTER] to conrm your entry.
Cutting Output
2. Cutting Method 85