Roland TrueVIS VG2-540 - Page 85

CONTINUE ADJ.?
YES [DONE]
13. Press [ENTER] to conrm your entry.
• If you select "YES", proceed to the next procedure.
• If you select "DONE", proceed to step 4.Save the sengs as a preset.(P. 85).
14. Press [▲] or [▼] to adjust the blade force.
• If the two shapes are peeled o together → increase the blade force.
• If the backing paper is also cut → reduce the blade force.
CUT FORCE
50gf 60gf
15. Press [ENTER] to conrm your entry.
The test paern is cut again. Check the result.
16. Check how the two shapes peel o.
• Two shapes are peeled o together/backing paper is also cut
Press [◀] to select "YES".
CONTINUE ADJ.?
[YES] DONE
• Two shapes are peeled o separately
Press [▶] to select "DONE".
CONTINUE ADJ.?
YES [DONE]
17. Press [ENTER] to conrm your entry.
• If you select "YES", the test paern is cut again. Go back to step 12 and perform the seng again.
• If you select "DONE", proceed to step 4.Save the sengs as a preset.(P. 85).
Cutting Output
84 2. Cutting Method