Shimadzu CBM-20A - Page 340

9. Technical Information
9-4
CBM-20A/20Alite
9.1.2 Installation
 Installation
The instrument is designed for stacking with other Shimadzu HPLC components.
"9.7 Introduction to HPLC System" P. 9-53
 Stacking Brackets
Fig. 9.3
The use of commercially available stacking brackets is recommended. These brackets limit
the possibility of the instrument falling off the lab table during an earthquake or the like.
Various grades of stacking brackets are available.
Fasten the instrument firmly in place by attaching stacking brackets to both the right and left
sides.
For more details, contact your Shimadzu representative.
An example of stacking bracket placement is shown in "Fig. 9.3".
CAUTION
When the LC-20A series components are stacked on each
other, the clearance between the components is only 5 mm.
Use caution to avoid pinching your fingers between the
components.
Fig. 9.2
Safety
bracket
Safety
bracket