SICK microScan3 User Manual

Addressing
If communic
ation between the device and a controller or a computer will be established
via TCP/IP, please enter the IP settings here.
b
Enter IP adress, Subnet and, if applicable, Router.
b
Activate the Save the IP address in the device. option.
✓
The IP address will be stored in the device so that it is retained even after switch‐
ing the system off and on again. It can be changed, however, from the PROFINET
controller.
Reading and transmitting values
If t
he values in the project and the values in the device differ, you can read the values
out from the device and adopt them in the project. Alternatively, you can transmit
values from the project to the device.
b
Click on Read from device.
✓
The values are read from the device and adopted in the project.
b
Click on Transfer to device.
✓
The values from the project are transmitted to the device.
7.4.1.1 Identification and maintenance
Overview
Figure 62: Identification and maintenance function in PROFINET
1
Values in the project
2
Values in the device
CONFIGURATION 7
8021219/1ELL/2022-01-21 | SICK O P E R A T I N G I N S T R U C T I O N S | microScan3 – PROFINET
95
Subject to change without notice

SICK microScan3 Specifications

General

Scanning angle	275°
Power supply	24 V DC
Supply voltage	24 V DC ± 20%
Enclosure rating	IP65
Resolution	70 mm
Protective field range	5.5 m
Number of fields	128
Interface	Ethernet
Safety integrity level	SIL3
Performance level	PL e
Ambient temperature	+50°C
Scanning range	5.5 m