SICK S3000 PROFINET IO

M6×8
Figure 41: Threaded holes for direct mounting
NOTE
Use a
t least mounting kit 1. This will make the device easier to remove.
5.2.2 Mounting using mounting kit 1
Overview
Y
ou can use mounting kit 1 to mount the device indirectly on the mounting surface.
This is always necessary if you cannot drill through the mounting surface from the rear.
MOUNTING 5
8013291/ZA19/2019-11-14 | SICK O P E R A T I N G I N S T R U C T I O N S | S3000 PROFINET IO, S3000 PROFINET IO-OF
53
Subject to change without notice