SICK S3000 PROFINET IO User Manual

Exporting field sets and fields
1.
Click on Export field sets to XML file.
2. Select the relevant folder and enter a file name for storing the field set informa‐
tion.
3. Start the export.
✓
The field sets and fields will be exported.
7.10.3 Protective field or warning field suggested by the safety laser scanner
The CDS can suggest the protective field or warning field in the field set editor. For this
pur
pose, the safety laser scanner scans the visible surrounding contour several times.
From the data obtained, the CDS suggests the contour and size of the field. The follow‐
ing figure shows an example for the reading of a protective field:




Figure 63: Reading the protective field
In t
hose places at which the surrounding contour is smaller than the maximum protec‐
tive field range (e.g., at 1), the protective field 4 corresponds to the surrounding con‐
tour.
NOTE
T
he measuring error tolerances for the device are automatically subtracted from the
protective field size. As a result the protective field is slightly smaller than the surface
covered 2.
In those places where the surrounding contour is larger than the protective field range
3, t
he protective field corresponds to the possible scanning range.
CONFIGURATION 7
8013291/ZA19/2019-11-14 | SICK O P E R A T I N G I N S T R U C T I O N S | S3000 PROFINET IO, S3000 PROFINET IO-OF
81
Subject to change without notice

SICK S3000 PROFINET IO Specifications

General

Field of view	190°
Response time	8 ms ... 80 ms
Protection class	IP65
Number of simultaneously monitored fields	4
Scanning angle	190°
Number of inputs	2
Number of outputs	4
Angular Resolution	0.5°
Interfaces	PROFINET IO
Operating temperature	0 °C ... +50 °C
Resolution for object detection	30 mm
Supply voltage	24 V DC
Type	Laser Scanner
Operating Voltage	24 V DC
Ambient Temperature	0 °C ... +50 °C
Storage Temperature	–25 °C ... +70 °C
Protective field range	0.2 m to 3 m
Protection Field Range	0.2 m to 3 m