Commissioning
5
5.1 Commissioning guidelines
Overview
7KHLQYHUWHULV
LQVWDOOHG
&RPPLVVLRQLQJLV
FRPSOHWHG
3UHSDUHIRU
FRPPLVVLRQLQJ
3HUIRUPTXLFN
FRPPLVVLRQLQJ
,VWKH
IDFWRU\VHWWLQJ
VXIILFLHQW"
'RHVWKH
LQYHUWHUKDYHWKH
IDFWRU\VHWWLQJ"
,VTXLFN
FRPPLVVLRQLQJ
VXIILFLHQW"
1R
<HV
3HUIRUPH[WHQGHG
FRPPLVVLRQLQJ
%DFNLQJXSGDWD
1R
<HV
5HVWRUHWKHIDFWRU\
VHWWLQJVIRUWKHLQYHUWHU
1RRUXQNQRZQ
<HV
1. Define the requirements to be met
by the drive for your application.
(Page 147)
2. Restore the factory settings of the
inverter if necessary.
(Page 189)
3. Check if the factory setting of the
inverter is sufficient for your
application.
(Page 151)
4. Set the following for quick
commissioning of the drive:
– The closed-loop motor control
– The inputs and outputs
– The fieldbus interface
(Page 153)
5. Check if additional inverter
functions are required for the
application.
(Page 191)
6. If necessary, adapt the drive.
(Page 191)
7. Save your settings.
(Page 369)
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE 145
To Next Page
Loading...
Need help?
General