Siemens CU240B-2 Operating Instructions

A.1.2 Firmware version 4.7 SP6
Table A-2 New functions and function changes in firmware 4.7 SP6
Function SINAMICS
G120 G120D
*0
*&
&83
&8%
&8(
&86
&8'
&8'
(7SUR)&
1 Support for the Power Module PM240-2, FSF frame sizes - - ✓ ✓ ✓ ✓ - - -
Support of PM240P‑2 Power Modules frame sizes FSD … FSF - - ✓ ✓ ✓ - - - -
Support of safety function Safe Torque Off (STO)via the terminals of the
PM240‑2 Power Module, frame size FSF and PM240P‑2 Power Module
FSD … FSF
You can find additional information in the "Safety Integrated" function man‐
ual.
Overview of the manuals (Page 537)
- - - - ✓ ✓ - - -
2 Support for Power Module PM330 JX frame size - - ✓ - - - - - -
3 Support for 1PC1 induction motors ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
4 The control of synchronous reluctance takes into account the inductance
of the output reactor.
- - ✓ - - - - - -
5 Support of motor temperature sensor Pt1000 ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
6 New p4621 parameter for disabling PTC short-circuit monitoring - - - - - - ✓ ✓ ✓
7 Revision of the thermal motor model for protecting the motor against dam‐
age due to overheating in the stator or rotor
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
8 Changing the quick commissioning in the "Standard Drive Control" appli‐
cation class:
The motor data identification is no longer permanently set to p1900 = 12;
instead, users select the appropriate motor data identification.
Factory setting: p1900 = 2.
- ✓ ✓ ✓ ✓ ✓ - - -
9 The free function blocks are also available in the SINAMICS G120C. ✓ ✓ ✓ ✓ ✓ ✓ ✓ - -
Changes in the current manual (Page 5)
Appendix
A.1 New and extended functions
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE 517

Siemens CU240B-2 Specifications

General

Brand	Siemens
Model	CU240B-2
Category	Inverter
Language	English