5.5.4 Select the application class
Starting quick commissioning
Procedure
Proceed as follows to start the quick commissioning:
When selecting an application class, the inverter assigns the motor control with the appropriate
default settings:
● [1]
Standard Drive Control (Page 181)
● [2] Dynamic Drive Control (Page 182)
● [0] Expert - or if no application class is listed:
Expert (Page 183)
Commissioning
5.5 Quick commissioning with a PC
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE 179
To Next Page
Loading...
Need help?
General