3.6 Motors and multi-motor drives that can be operated
Siemens motors that can be operated
You can connect standard induction motors to the inverter.
You can find information on further motors on the Internet:
Motors that can be operated (
https://support.industry.siemens.com/cs/ww/en/view/
100426622)
Third-party motors that can be operated
You can operate standard asynchronous motors from other manufacturers with the inverter:
NOTICE
Insulation failure due to unsuitable third-party motor
A higher load occurs on the motor insulation in inverter mode than with mains operation.
Damage to the motor winding may occur as a result.
● Please observed the notes in the System Manual "Requirements for third-party motors"
Further information is provided on the Internet:
Requirements for third-party motors (https://support.industry.siemens.com/cs/ww/en/view/
79690594)
Multi-motor drive
A multi-motor drive involves simultaneously operating several motors from one inverter. For
standard induction motors, multi-motor drives are permissible in installations that are compliant
with IEC.
Further information is provided on the Internet:
Multi-motor drive (http://support.automation.siemens.com/WW/view/en/84049346)
Multi-motor drives are not permissible for installations that are compliant with UL.
Description
3.6 Motors and multi-motor drives that can be operated
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE 55
To Next Page
Loading...
Need help?
General