Parameters of the fault buffer and the fault history
Parameter Description
r0945 Fault code
Displays the numbers of the faults that have occurred
r0948 Fault time received in milliseconds
Displays the time in milliseconds when the fault occurred
r0949 Fault value
Displays additional information about the fault
p0952 Fault cases, counter
A fault case can contain one or several faults.
Number of fault cases that have occurred since the last acknowledgement. With p0952
= 0 you delete the fault buffer and the fault history.
r2109 Fault time removed in milliseconds
Displays the time in milliseconds when the fault occurred
r2130 Fault time received in days
Displays the time in days when the fault occurred
r2131 Actual fault code
Displays the code of the oldest fault that is still active
r2133 Fault value for float values
Displays additional information about the fault that occurred for float values
r2136 Fault time removed in days
Displays the time in days when the fault was removed
Extended settings for faults
Parameter Description
p2100[0 … 19] Setting the fault number for fault response
Selecting the faults for which the fault response should be changed.
You can modify the motor fault response for up to 20 different fault codes.
p2101[0 … 19] Setting, fault response
Setting the fault response for the selected fault
p2118[0 … 19] Setting the message number for the message type
Selection of the message for which the message type should be changed.
You can change up to 20 different faults into an alarm, or suppress faults:
p2119[0 … 19] Setting the message type
Setting the message type for the selected fault
1: Fault
2: Alarm
3: No message
Alarms, faults and system messages
8.5 Faults, alarm buffer and alarm history
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE 405
To Next Page
Loading...
Need help?
General