Commissioning and Diagnostics
5-46
ET 200X Distributed I/O Device
EWA 4NEB 780601602-06
Diagnostic interrupt of modules with digital outputs
Byte x+4
Module malfunction, i. e. a problem has been detected
0
Byte x+5
0
External error: Module no longer addressable
27
Parameterization error
Internal fault in module
Channel fault in module
Parameters not assigned to module
136
Byte x+8
70
72
H
: Module with digital outputs
Byte x+9
7
Length of channel-specific diagnosis
70
Number of channels per module
Byte x+10
0
Byte x+11
70
Diagnostic event on channel 0 of module
Byte x+12
7
0
Configuration or parameter assignment error
0
Diagnostic event on channel 1 of module
1
Channel 0
Short-circuit to M
3
Wire break
4
Byte x+19: Assignment for channel 7 as for byte x+12
Byte x+13: Assignment for channel 1 as for byte x+12
1F
H
: Module class, digital module
External auxiliary supply is missing, i. e.:
Load power supply is missing or is too low
4
Bytes x+6 to x+7: Are not used
23
6
Temperature rise
Byte x+14: Assignment for channel 2 as for byte x+12
:
Short circuit to L+
2
5
4
56
:
:
51
7
Diagnostic event on channel 7 of module
Diagnostic events for channel 0
0
00
Figure 5-14 Structure as of byte x+4 for diagnostic interrupt (digital outputs)
To Next Page
Loading...
