Siemens SIMATIC ET 200X - Configuration as of Byte X+4 for Diagnostic Interrupt (Analog Outputs)

Commissioning and Diagnostics
5-49
ET 200X Distributed I/O Device
EWA 4NEB 780601602-06
Diagnostic interrupt of modules with analog outputs
70
7
Module in STOP mode
Byte x+7: Is not used
0
2
73
H
: Module with analog outputs
Length of channel-specific diagnosis
Number of channels per module
Bytes x+14 to x+19: Are always 00
H
Byte x+13: Assignment for channel 1 as for byte 12
15
H
: Module class, analog module
Module malfunction, i. e. a problem has been detected
0
External error: Module no longer addressable
27
Parameterization error
Internal fault in module
Channel fault in module
Parameters not assigned to module
13645
Byte x+4
Byte x+5
Byte x+6
Byte x+8
70
Diagnostic event on channel 0 of module
Diagnostic event on channel 1 of module
1
23
Diagnostic event on channel 3 of module
4
56
:
7
0
Configuration or parameter assignment error
0
Short-circuit to M
3
Wire break
462
51
Byte x+11
00
Byte x+9
Byte x+10
Byte x+12
Diagnostic events for channel 0
Byte x+14: Assignment for channel 2 as for byte 12
Byte x+13: Assignment for channel 3 as for byte 12
00
00
Figure 5-17 Configuration as of byte x+4 for diagnostic interrupt (analog outputs)