iii
ET 200X Distributed I/O Device
EWA 4NEB 780601602-06
Preface
Purpose of the manual
The information contained in this manual will enable you to operate the ET 200X
distributed I/O device as a DP slave on PROFIBUS-DP.
Required basic knowledge
General knowledge of automation engineering is required to understand the
manual.
Scope of validity of the manual
This manual is valid for the ET 200X distributed I/O system components specified
in Appendix A.
This manual contains a description of the components that were valid at the time
the manual was published. We reserve the right to enclose a Product Information
bulletin containing up-to-date information about new components and new versions
of components.
Changes since the previous version
Compared to the previous version, the manual contains the following changes and
additions:
DPV1 support of DPV1 of all basic modules with DDB file SI0380**.GS*
Note: You can recognize the previous version of this ET 200X manual by the
number EWA-4NEB 78060160x-04 in the footer.
The current number is EWA-4NEB 78060160x-05.
Certification
See Section 6.1 Standards, certificates, and approvals.
CE certification
See Section 6.1 Standards, certificates, and approvals.
Identification code for Australia (C-tick mark)
See Section 6.1 Standards, certificates, and approvals.
To Next Page
Loading...
