Order Numbers
A-3
ET 200X Distributed I/O Device
EWA 4NEB 780601602-06
Accessories for ET 200X
Table A-3 Accessories for ET200X – order numbers
Description Order number
Connector assembly for PROFIBUS-DP, supply
voltage for electronic components/sensors and load
voltage
(protective shell with 6-pin connector,
2 M16 cable glands and 2 lock nuts)
6ES7 194-1AA01-0XA0
Cover plate
(for sealing off unused connectors for PROFIBUS-DP
and supply/load voltage; 10 units)
6ES7 194-1JB00-0XA0
M12 coupler plug, 5-pin
(for connecting actuators and sensors)
On request
M12 angular coupler plug, 5-pin
(for connecting actuators and sensors; cannot be
used in conjunction with an M12 Y connector)
On request
M12 Y connector, 5-pin (for dual connection of
actuators/sensors to digital inputs/outputs)
6ES7 194-1KA01-0XA0
AS interface, M12 screw cap
(for sealing off unused inputs and outputs of the
ET 200X; 10 units)
3RX9 802-0AA00
Silencer for pneumatic module 6ES7 194-1EA00-0XA0
DIN rail, narrow, length 400 mm
for ET 200X electronic submodule
6ES7 194-1GA00-0XA0
DIN rail, narrow, length 640 mm
for ET 200X electronic submodule
6ES7 194-1GA10-0XA0
DIN rail, narrow, length 2000 mm
for ET 200X electronic submodule
6ES7 194-1GA20-0XA0
DIN rail, wide, length 520 mm
for ET 200X electronic module and motor
starter/frequency converter
6ES7 194-1GB00-0XA0
DIN rail, wide, length 1000 mm
for ET 200X electronic submodule and motor
starter/frequency converter
6ES7 194-1GB10-0XA0
Screws with washer assemblies
(100 screws M5 x 20, crossed recessed head with
washer) for fitting ET 200X modules onto DIN rail
6ES7 194-1KC00-0XA0
To Next Page
Loading...
