Installation
3-6
ET 200X Distributed I/O Device
EWA 4NEB 780601602-06
Installing the ET 200X
1. Use M8 screws to secure the DIN rail to the substrate at all the fixing points
provided.
2. Remove the cover panel from the expansion port of the basic module.
3. Screw the basic module to the DIN rail at the 4 fixing points using cross-recess
M5 x 20 screws
Tightening torque: 2 Nm (max. 3 Nm)
4. Plug the expansion module into the expansion interface of the basic module
and fasten the modules using two M3.5 x 25 screws.
To Next Page
Loading...
