Siemens SINAMICS G130 - Page 135

Commissioning
5.3 Procedure for commissioning via STARTER
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
135
Figure 5-8 Complete setting the interface
⇒
Click
Continue >
to set up a drive unit in the project wizard.
Figure 5-9 Inserting the drive unit
⇒
Choose the following data from the list fields:
Device:
Sinamics
Type:
G130 CU320-2 DP or G130 CU320-2 PN
Version:
4.8
Target device address:
the corresponding bus address for the converter.
The entry in the
Name:
can be freely selected.
⇒
Click
Insert
The selected drive unit is displayed in a preview window in the project wizard.