Siemens SINAMICS G130 - Page 134

Commissioning
5.3 Procedure for commissioning via STARTER
Inverter chassis units
134 Operating Instructions, 07/2016, A5E00331449A
Figure 5-7 Setting the interface - properties
Note
Activate PG/PC is the only master on the bus
You must activate PG/PC is the only master on bus
if no other master (PC, S7, etc.) is
available on the bus.
Note
Configure even without an interface
Projects can be created and PROFIBUS addresses for the drive objects assigned even if a
PROFIBUS interface has not been installed on the PC.
To prevent bus
addresses from being assigned more than once, only the bus addresses
available in the project are proposed.
When required, a manual address entry can also be used to enter an already assigned
address.
⇒
After completion, click
OK
to confirm the settings and to return to the project wizard.