Siemens SINAMICS G130 - Page 148

Commissioning
5.3 Procedure for commissioning via STARTER
Inverter chassis units
148 Operating Instructions, 07/2016, A5E00331449A
Note
Entering equivalent circuit diagram data
You should only activate the Enter optional equivalent circuit diagram data
if the data sheet
with equivalent circuit diagram data is available. If any data is missing, an error message will
be output when the system attempts to load the drive project to the target system.
⇒
Click
Continue >
Configuring the motor – Entering optional data
Figure 5-21 Entering optional motor data
⇒
enter the optional motor data.
⇒
Click
Continue >