Siemens SINAMICS G130 - Page 150

Commissioning
5.3 Procedure for commissioning via STARTER
Inverter chassis units
150 Operating Instructions, 07/2016, A5E00331449A
Calculating the motor/controller data
Figure 5-23 Calculating the motor/controller data
⇒
In
Calculation of the motor/controller data
, select the appropriate default settings for your
device configuration.
Note
Manual input of the equivalent circuit diagram data
If the equivalent circuit diagram data was entered manually (see "Entering the equivalent
circuit diagram data"), then the motor/controller data should be calculated without
cal
culating
the equivalent circuit diagram data.
⇒
Click
Continue >