Siemens SINAMICS G130 - Page 153

Commissioning
5.3 Procedure for commissioning via STARTER
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
153
⇒
To select a different predefined encoder configuration, check the
Select standard encoder
from list
radio button and select one of the encoders from the list.
⇒
To enter special encoder configurations, click the
Enter data
radio button and then the
Encoder data
button. The following input screen is displayed for you to enter the required
data.
Figure 5-26 Entering encoder data – User-defined encoder data
⇒
Select the
measuring system
.
You can choose the following encoders in conjunction with SINAMICS G130:
● HTL
● TTL
⇒
Enter the required encoder data.
⇒
under the
Details
tab, special encoder properties can be set, for example, gear ratio, fine
resolution, inversion, measuring gear position tracking.
⇒
Click
OK
.