Siemens SINAMICS G130 - Page 152

Commissioning
5.3 Procedure for commissioning via STARTER
Inverter chassis units
152 Operating Instructions, 07/2016, A5E00331449A
Entering the encoder data (option: SMC30 Sensor Module)
Note
Entering the encoder data
If you specified the SMC30 Sensor Module when choosing the options, the Following input
screen is displayed in which you can enter the en
coder data.
Figure 5-25 Entering the encoder data
⇒
In the
Encoder name:
field, enter a name of your choice.
Note
Delivery condition
The delivery condition is a bipolar HTL encoder with 1024 pulses per revolution at terminal
X521/X531 of the encoder module SMC30.