Siemens SINAMICS G130 - Page 155

Commissioning
5.3 Procedure for commissioning via STARTER
Inverter chassis units
Operating Instructions, 07/2016, A5E00331449A
155
The following command and setpoint source options are available:
Command sources:
PROFIdrive (default)
TM31 terminals
CU terminals
PROFIdrive+TM31
Setpoint sources:
PROFIdrive (default)
TM31 terminals
Motorized potentiometer
Fixed setpoint
Note
Use of CDS0
With SINAMICS G130, only CDS0 is normally used as a default setting for the command and
setpoint sources.
Make sure that the selected default setting is compatible with the actual system
configuration.
Note
Do not use a selection
The choice "no selection" is also available as default setting for the command and setpoint
sou
rces; if selected, no default settings are applied for the command and setpoint sources.
⇒
Check your default settings carefully and then click
Continue >