Siemens SINUMERIK 802D sl Function Manual

Contents
Turning, Milling, Nibbling
12 Function Manual, 11/2012, 6FC5397-1CP10-5BA0
8.6.2 Setting data ............................................................................................................................... 154
8.6.3 Interface signals ........................................................................................................................
155
9 Auxiliary Function Outputs to PLC (H2) .................................................................................................
157
9.1 Brief description ........................................................................................................................
157
9.2 Programming of auxiliary functions...........................................................................................
158
9.3 Transfer of values and signals to the PLC interface .................................................................
159
9.4 Grouping of auxiliary functions..................................................................................................
160
9.5 Block-search response..............................................................................................................
162
9.6 Description of the auxiliary functions ........................................................................................
162
9.6.1 M function..................................................................................................................................
162
9.6.2 T function...................................................................................................................................
163
9.6.3 D function ..................................................................................................................................
163
9.6.4 H function ..................................................................................................................................
163
9.6.5 S function ..................................................................................................................................
164
9.7 Data lists....................................................................................................................................
164
9.7.1 Machine data.............................................................................................................................
164
9.7.2 Interface signals ........................................................................................................................
164
10 Operating Modes, Program Operation (K1) ...........................................................................................
167
10.1 Brief description ........................................................................................................................
167
10.2 Operating modes.......................................................................................................................
167
10.2.1 Mode change ............................................................................................................................
169
10.2.2 Functional possibilities in the individual modes ........................................................................
170
10.2.3 Monitoring functions in the individual modes ............................................................................
171
10.2.4 Interlocks in the individual modes .............................................................................................
172
10.3 Processing a part program........................................................................................................
173
10.3.1 Program mode and part program selection ..............................................................................
173
10.3.2 Start of part program or part program block..............................................................................
173
10.3.3 Part program interruption ..........................................................................................................
174
10.3.4 RESET command .....................................................................................................................
175
10.3.5 Program control.........................................................................................................................
176
10.3.6 Program status..........................................................................................................................
176
10.3.7 Channel status ..........................................................................................................................
177
10.3.8 Eventdriven program calls.........................................................................................................
178
10.3.9 Asynchronous subroutines (ASUBs).........................................................................................
186
10.3.10 Responses to operator or program actions...............................................................................
188
10.3.11 Example of a timing diagram for a program run........................................................................
190
10.4 Program test..............................................................................................................................
191
10.4.1 General information on the program test ..................................................................................
191
10.4.2 Program processing without axis movements (PRT)................................................................
191
10.4.3 Program processing in single block mode (SBL)......................................................................
192
10.4.4 Program processing with dry run feedrate (DRY).....................................................................
193
10.4.5 Block search: Processing of certain program sections .............................................................
194
10.4.6 Skip part program blocks (SKP)................................................................................................
197
10.4.7 Graphic simulation ....................................................................................................................
198
10.5 Timers for program execution time ...........................................................................................
199

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English