Siemens SINUMERIK 802D sl Function Manual

Contents
Turning, Milling, Nibbling
16 Function Manual, 11/2012, 6FC5397-1CP10-5BA0
20.4 Gear stage change.................................................................................................................... 353
20.5 Programming.............................................................................................................................
357
20.6 Spindle monitoring ....................................................................................................................
359
20.6.1 Axis/spindle stationary ..............................................................................................................
359
20.6.2 Spindle in setpoint range...........................................................................................................
360
20.6.3 Maximum spindle speed ...........................................................................................................
360
20.6.4 Minimum/maximum speed for gear stage.................................................................................
360
20.6.5 Max. encoder limit frequency ....................................................................................................
361
20.6.6 Target point monitoring .............................................................................................................
362
20.7 2nd spindle / master spindle .....................................................................................................
363
20.8 Analog spindle...........................................................................................................................
365
20.9 Data lists....................................................................................................................................
365
20.9.1 Machine data.............................................................................................................................
365
20.9.2 Setting data ...............................................................................................................................
366
20.9.3 Interface signals ........................................................................................................................
366
21 Indexing Axes (T1).................................................................................................................................
369
21.1 Brief Description........................................................................................................................
369
21.2 Indexing axes ............................................................................................................................
370
21.2.1 General information...................................................................................................................
370
21.2.2 Traversing indexing axes in manual JOG mode.......................................................................
370
21.2.3 Traversing indexing axes in AUTOMATIC modes ....................................................................
372
21.2.4 Traversing of indexing axes by PLC .........................................................................................
372
21.3 Parameterization of indexing axes............................................................................................
373
21.4 Programming of indexing axes..................................................................................................
375
21.5 Starting up indexing axes..........................................................................................................
376
21.6 Special features of indexing axes .............................................................................................
379
21.7 Data lists....................................................................................................................................
380
21.7.1 Machine data.............................................................................................................................
380
21.7.2 Interface signals ........................................................................................................................
380
22 Tangential Control (T3)..........................................................................................................................
381
22.1 Brief description ........................................................................................................................
381
22.2 Characteristics of "Tangential control" function ........................................................................
382
22.3 Use of "Tangential control" function..........................................................................................
384
22.3.1 Overview ...................................................................................................................................
384
22.3.2 Definition of axis coupling: TANG .............................................................................................
385
22.3.3 Switching on the axis coupling: TANGON ................................................................................
385
22.3.4 Response at corners, activation "with intermediate block": TLIFT............................................
386
22.3.5 Switching off the axis coupling: TANGOF.................................................................................
386
22.3.6 Deactivation of corner response "with intermediate block".......................................................
386
22.3.7 Deleting the definition of axis coupling: TANGDEL ..................................................................
387
22.3.8 Programming examples ............................................................................................................
387
22.4 Limit angle for reversal of path direction ...................................................................................
388
22.5 Data lists....................................................................................................................................
389

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English