Siemens SINUMERIK 802D sl - Page 180

Operating Modes, Program Operation (K1)
10.3 Processing a part program
Turning, Milling, Nibbling
180 Function Manual, 11/2012, 6FC5397-1CP10-5BA0
Table 10- 8 Sequence at part program end
Seque
nce
Command Boundary conditions
(must be satisfied before the
command)
Comments
1 Channel selection: Reset status
Operating mode selection: AUTO or
AUTO and overstoring or
MDA or TEACH IN
None Select channel and mode
2 NC Start Block with end of part program Block is changed
3 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
MD20152 GCODE_RESET_MODE
Control activated:
Reset sequence with evaluation
4 /_N_CMA_DIR/_N_PROG_EVENT_SPF or
name from MD11620
as an ASUB Implied call of the path name as
an ASUB
5 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
MD20152 GCODE_RESET_MODE
Control activated:
Reset sequence with evaluation
The G code reset position
continues to be specified with
machine data
Event
Operator panel reset
Table 10- 9 Processing sequence in operator panel reset
Seque
nce
Command Boundary conditions
(must be satisfied before the
command)
Comments
1 Selection of channel and mode:
any
Initial state: Any mode, any
channel status
Select mode / channel status
from
any state
2 Reset
3 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
MD20152 GCODE_RESET_MODE
Control activated:
Reset sequence with evaluation
4 /_N_CMA_DIR/_N_PROG_EVENT_SPF or
name from MD11620
as an ASUB Implied call of the path name as
an ASUB
5 MD20110 RESET_MODE_MASK,
MD20150 GCODE_RESET_VALUES,
MD20152 GCODE_RESET_MODE
Control activated:
Reset sequence with evaluation
The G code reset position
continues to be specified with
machine data
Event
Startup