Commissioning Manual
44 6FC5397-4EP10-0BA8, 07/2018
-click the access point symbol, and the following "Set PG/PC Interface" dialog box is
Select "TCP/IP" with the Ethernet card name of your computer and click the "OK" but
ton.
Note: You can find the name of your Ethernet card in the local area connection status under
Control Panel on your computer.
Enter the IP address for the control system that displays in the above link setup dialog box
in the communication settings
dialog box.
-click this symbol in the communication setting window to establish a connection to
the specified IP address.
Wait until the information of the connected control system is identified as follows, and then
the connection is ready.
Establishing a network connection
Proceed through the following steps to establish a network connection:
Connect the control system with the local network using an Ethernet cable.
Select the system data operating area on the PPU.
Press this key to view the extended softkeys.
Enter the main screen of the service control options through the following softkey oper
a-
To Next Page
Loading...
Need help?
General
