1
1-13
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D/810D Start-Up Guide (IADC) – 03/2006 Edition
General preparation
1.1 Preconditions
This Installation and Start-Up Guide describes the procedure for starting up the
basic control functions including drive-related functions. Further reference mate-
rial on special NCK, HMI, PLC or drive functions can be found in the Function
Descriptions/Manuals (see “Documentation required”).
You will need the following software for starting up the SINUMERIK 840D:
1. SinuComNC start-up/service tools
Supplied on CD-ROM with:
– SinuCom NC
– SinuCom FFS
– SinuCom ARC
– SinuCom PCIN
– Start-up tool
2. SIMATIC Step7
3. Tool-Box for SINUMERIK powerline with:
– Basic PLC program
– NC variable selector
– Sample programs
4. For HMI Embedded, application diskette or CompactFlash card for creating
PLC alarm texts and transferring them to the PCU (supplied with the HMI
system software).
You will need the following devices and accessories for starting up the
SINUMERIK 840D:
1. PC/PG for SinuComNC start-up/service tools and SIMATIC Step7
2. MPI cable for PC/PG
3. V24 cable with 9-pin connector (socket)
Introduction
Software required
Required devices
and accessories
1
To Next Page
Loading...
