8
8-163
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D/810D Start-Up Guide (IADC) – 03/2006 Edition
Alarm and Message Texts
To allow alarm and message texts to be easily modified to suit the requirements
of a specific automation system, the alarm and message texts are stored in
ASCII format in freely accessible text files.
8.1 Alarm text files for HMI Embedded
When the HMI Embedded application diskette is installed (see chapter 12), the
S configuration settings,
S texts,
S the configured interface and
S the user software
are transferred from the update directory on your PC/PG to the PCU 20 hard-
ware. The ways in which the alarm text files can be adapted beforehand are
described here.
S PC with DOS 6.x
S V.24 cable between the COM1 port on the PCU (X6) and the COM1 or
COM2 port on your PC
S Approx. 3 MB free space on hard disk
S The following description assumes that you have already transferred the
software from the HMI Embedded application diskette (diskette 2) to the
hard disk of the PC/PG (as described in chapter 12).
The texts are stored with the Siemens defaults n the selected drive on your PC.
For the sake of simplicity, it is assumed that this is always C: in the following
description. The directory is:
C:\mmc 100 pj\proj\text\<LANGUAGE DIRECTORY>
Depending on the selected language, one of the following letters stands for
<LANGUAGE DIRECTORY>:
D for German
G for English
F for French
E for Spanish
I for Italian.
Description
Preconditions
Alarm texts/
message texts
8
To Next Page
Loading...
