Siemens SINUMERIK 840D Simodrive 611 digital - 12.4 Standard System Start-up via NC Card

12
03/2006
12.4 Standard system start-up via NC card
12-267
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D/810D Start-Up Guide (IADC) – 03/2006 Edition
12.2 Software upgrade for HMI Embedded
The entire HMI Embedded software package is supplied on a CD-ROM. The
software is loaded using the Service menu.
The software upgrade procedure is described in the following publication:
Reference material: /IAM/ IM2, HMI EmbeddedStart-up Guide
12.3 Software upgrade for HMI Advanced
The entire HMI Advance software package is supplied on a CD-ROM. The soft-
ware is loaded using the Service menu.
The software upgrade procedure is described in the following publication:
Reference material: /IAM/ IM4, HMI AdvancedStart-up Guide
12.4 Standard system start-up via NC card
The free memory on the NC card (PCMCIA card) can be used to save a start-up
archive there. The archive can be copied to the NC card using SINUCOPY-FFS
(on an external PG/PC).
Possible applications:
1. After replacing an NC module (or another form of data loss), the user can
restore the machine to its original state as it was supplied by the manufacturer
using the archive stored on the NC card or
2. The machine manufacturer can provide the cycles and data in the archive on
the NC card when he supplies the machine or a software upgrade.
You have the option of transferring Siemens and/or machine manufacturer
cycles from the flash file system on the NC card to the DRAM when the control
powers up and running them from there. The configuration for this and the
behavior of the DRAM cycles are described in 12.4.1.
Form supplied
Form supplied
12 Re
p
lacin
g
Software and Hardware