1
03/2006
1.2 Standard/export variants
1-15
© Siemens AG 2006 All Rights Reserved
SINUMERIK 840D/810D Start-Up Guide (IADC) – 03/2006 Edition
The hardware components supplied with system software are, in addition to any
information on the delivery note and invoice, clearly identified by as standard or
export variants by means of stickers.
Note
The additional stickers supplied in the packaging are intended to identify the
control after start-up, and should be stuck into the control’s logbook. When
licenses are ordered, a corresponding number of stickers is supplied. These
should be used in the same way.
Once the control has powered up, the export variant can be identified by the
additional letter ‘E’ on the Service screen (NCK information). It is important for
Service to be able to identify the control variant in this way. It can also serve to
provide the necessary verification for exports, particularly if existing negative
certificates for the export variant are used.
J
Identification of
the control
1 General Pre
aration
To Next Page
Loading...
