Siemens SIPROTEC 4 7UT6 Series - Page 176

No. Information Type of
Informa-
tion
Comments
049.2411 CLP OFF OUT Cold-Load-Pickup switched OFF
049.2412 CLP BLOCKED OUT Cold-Load-Pickup is BLOCKED
049.2413 CLP running OUT Cold-Load-Pickup is RUNNING
049.2505 >BLK CLP stpTim SP >BLOCK Cold-Load-Pickup stop timer
192.2413 3I0 Dyn.set.ACT OUT Dynamic settings O/C 3I0 are ACTIVE
208.2413 I-2 Dyn.set.ACT OUT Dynamic settings O/C Phase-2 are ACTIVE
210.2413 I-3 Dyn.set.ACT OUT Dynamic settings O/C Phase-3 are ACTIVE
322.2413 3I0-2 Dyn.s.ACT OUT Dynamic settings O/C 3I0-2 are ACTIVE
324.2413 3I0-3 Dyn.s.ACT OUT Dynamic settings O/C 3I0-3 are ACTIVE
326.2413 IE-2 Dyn.s. ACT OUT Dynamic settings O/C Earth-2 are ACTIVE
Functions
2.6 Dynamic Cold Load Pickup for Time Overcurrent Protection
176 SIPROTEC 4, 7UT6x, Manual
C53000-G1176-C230-5, Edition 09.2016