Assignment of Protection Functions to Protected Objects
Not every protection function implemented in the 7UT6x is useful or even possible for every conceivable
protected object. The following table shows which protection functions are possible for which protected
objects. Once a protected object has been configured (as described in Section 2.1.3 Functional Scope), only
those protection functions are allowed and settable that are valid according to the table below.
[zuordnung-schutzfunktion, 1, en_GB]
Figure C-19
Utilisation of the protective functions in different protected objects
C.3
Connection Examples
C.3 Assignment of Protection Functions to Protected Objects
SIPROTEC 4, 7UT6x, Manual 521
C53000-G1176-C230-5, Edition 09.2016
To Next Page
Loading...
Need help?
General
