Mounting and Commissioning
This chapter is primarily intended for experienced commissioning engineers. The commissioning engineer
must be familiar with the commissioning of protection and control systems, with the management of power
systems and with the relevant safety rules and guidelines. Under certain circumstances adaptations of the
hardware to the particular power system data may be necessary. The primary tests require the protected
object (line, transformer etc.) to carry load.
3.1 Mounting and Connections 310
3.2 Checking Connections 349
3.3 Commissioning 354
3.4 Final Preparation of the Device 393
3
SIPROTEC 4, 7UT6x, Manual 309
C53000-G1176-C230-5, Edition 09.2016
To Next Page
Loading...
