Siemens siprotec 7SA6 - Page 8

viii 7SA6 Manual
C53000-G1176-C133-1
3.3.1 Operation Using the Operator Control Panel.......................................................................3-5
3.3.2 Operation Using DIGSI
®
4...................................................................................................3-8
3.4 Storage ............................................................................................................................. 3-13
4SIPROTEC
®
4 Devices ......................................................................................................................4-1
4.1 General................................................................................................................................4-2
4.1.1 Protection and Control.........................................................................................................4-2
4.1.2 Communication....................................................................................................................4-3
4.1.3 Settings................................................................................................................................4-5
4.1.4 Operations ...........................................................................................................................4-5
4.1.5 Oscillographic Fault Records...............................................................................................4-5
4.2 Operator Control Facilities................................................................................................... 4-6
4.2.1 Operator Control Panel On Device......................................................................................4-6
4.2.2 DIGSI
®
4 Tool......................................................................................................................4-8
4.3 Information Retrieval............................................................................................................4-9
4.3.1 Annunciations....................................................................................................................4-10
4.3.2 Measurements................................................................................................................... 4-12
4.3.3 Oscillographic Fault Records.............................................................................................4-14
4.4 Control ............................................................................................................................... 4-15
4.5 Manual Overwrite / Tagging...............................................................................................4-17
4.6 General about the Setting Procedures .............................................................................. 4-18
4.7 Configuration of the Scope of Device Functions................................................................4-21
4.8 Configuration of Inputs and Outputs (Configuration Matrix) ..............................................4-22
4.9 Programmable Logic CFC ................................................................................................. 4-25
4.10 Power System Data...........................................................................................................4-27
4.11 Setting Groups................................................................................................................... 4-28
4.12 General Device Settings.................................................................................................... 4-30
4.13 Time Synchronization ........................................................................................................4-31
4.14 Serial Interfaces................................................................................................................. 4-32
4.15 Passwords .........................................................................................................................4-34
5 Configuration ....................................................................................................................................5-1
5.1 Configuration of Functions...................................................................................................5-2
5.1.1 Settings................................................................................................................................5-5
5.2 Configuration of the Binary Inputs and Outputs...................................................................5-8
5.2.1 Preparation ..........................................................................................................................5-8
5.2.2 Structure and Operation of the Configuration Matrix ...........................................................5-9