Siemens siprotec 7SA6 User Manual

Control During Operation
7-24 7SA6 Manual
C53000-G1176-C133-1
7.1.3.4 Resetting of Metered Values and Minimum/Maximum Values
Metered values of measured values and minimum/maximum value memories can be
reset.
From the
Device Front
With the device ready for operation, first press the key. The0$,10(18 appears.
Use the key to select the menu item 0HDVXUHPHQW and switch to the list of
measured values using the key. The 0($685(0(17 selection appears.
There, select the menu item 5HVHWwith the key, and switch to the list of limit
values using the key (see Figure 7-25).
Figure 7-25 Setting of metered values and minimum/maximum values on front panel
With the keys and paging up and down in the table is possible.
To reset a memory, it must be marked by means of the keys and and
subsequently the key must be pressed.
A prompt for the entry of password No. 5 (for individual parameters) appears. After
entry of the password and confirmation with , the query “$UH\RXVXUH"”, with
the default answer “<HV” appears (Figure 7-25). Confirm with the key , if the
corresponding measured values should really be reset. A message in the display will
then show the answer “&KDQJHRN”. If you do not want to reset the measured values,
press the key, so that the answer “1R” is marked, and confirm with the key.
Before confirming with the key, the responses can be toggled between “<(6” and
“12” using the and keys. Alternatively, the key can be pressed to cancel the
resetting procedure.
Use the key to return to the 0($685(0(17 submenu. Use the key to return to
the 0$,10(18.
MENU
ENTER
3:6HWWLQJV"
 
Enter password Nr. 5 (for individual
parameters) and confirm with
ENTER
$UH\RXVXUH"
!<HV1R(VFDSH
Confirm “<(6” with the key and
complete the resetting of the selected
measured values, or switch to “12” with
the key and cancel the resetting with
the key.
ENTER
ENTER
5(6(7 

!5HV0LQ0D[!
!0HWHUUHV 
ENTER
ENTER
ENTER
ENTER
ENTER
ESC
MENU

Siemens siprotec 7SA6 Specifications

General

Brand	Siemens
Model	siprotec 7SA6
Category	Relays
Language	English