Siemens SIRIUS M200D - Page 130

Configuration / parameterization
5.2 Parameterize
M200D PROFIBUS/PROFINET
130 Manual, 08/2014, A5E01577426A/RS-AA/004
Device parameter
Default setting
Setting range
Input 1 signal Non-retentive
• Retentive
• Non-retentive
Input 2 signal
Input 3 signal
Input 4 signal
Output level 1 Not inverted
• Not inverted
• Inverted
Output level 2
Output 1 signal Continuous signal
• Continuous signal
• Flashing
Output 2 signal
Output 1 action Control source PIO DO 1.0 Triggering by means of external control
source
• Control source PIO DO 1.0
(output 1)
• Control source PIO DO 1.1
(output 2)
• Control source PIO DO 0.2
(brake output)
• Control source input 1
• Control source input 2
• Control source input 3
• Control source input 4
Actuation by motor starter
• Run-up
• Operation/shunting
• Coasting down
• On time motor (RUN)
• Control command motor ON
• Brake output
• Device ON
Actuation by messages from the motor
starter
• Group prewarning
• Group warning
• Group fault
• Bus error
• Device error
• Maintenance required
• Maintenance requested
• Ready for motor ON