Siemens SIRIUS M200D - Page 212

Appendix
A.1 Data formats and data sets
M200D PROFIBUS/PROFINET
212 Manual, 08/2014, A5E01577426A/RS-AA/004
Object
No.
Byte.Bit
Parameters / content
Range of values
Increment
Default
setting
Relevant for
80 41.0 Input 1 signal [0] Non-retentive /
[1] Retentive
— [0] All starters
81 41.1 Input 2 – Signal [0] Non-retentive
[1] Retentive
— [0]
82 41.2 Input 3 – Signal [0] Non-retentive
[1] Retentive
— [0]
83 41.3 Input 4 signal [0] Non-retentive
[1] Retentive
— [0]
38 46.0 ... 7 Start time 0 to 30 s
[0] Minimum ramp (100 ms)
0.25 s 5 s [20] sDSSte
sRSSte
39 47.0 ... 7 Run-down time 0 to 30 s
[0] Function deactivated
0.25 s 0 s
40 48.0 ... 7 Starting voltage 20 ... 100 % [4 ... 20] 5 % 40 %
41 49.0 ... 7 Stopping voltage 20 ... 90 % [4 ... 18] 5 % 40 %
42 50.0 ... 7 Current limit value 125 ... 600 %
For I
e
≥ 9 A → 125 % to 50 %
3.125 % 600 %
167 51.0 ... 3 Startup mode [0] Direct
[1] Voltage ramp
[4] Current limiting
[5] Voltage ramp + Current
limiting
— [0] sDSSte
sRSSte
168 51.4 ... 7 Run-down type [0] Run-down without load
[1] Voltage ramp
— [0] sDSSte
sRSSte
35 52 ... 53 Substitute value → See PIO — [0] All starters
36 56.6 Group diagnostics [0] Block
[1] Enable
— [0] All starters
34 56.7 Response to
CPU/master STOP
[0] Switch substitute value
[1] Retain last value
— [0] All starters
208 58 ... 59 Brake release delay on
starting
- 2.5 to 2.5 s 0.01 s 0 s All with BO
1)
209 60 ... 61 Brake holding time on
stopping
0 to 25 s 0.01 s 0 s All with BO
1)
— 73 Reserved (for input
level)
— — — —
151 93.0 ... 1 Output 1 - Level [0]: Not inverted
[1]: Inverted
[2 to 3]: Reserved
— [0] All starters
152 93.2 ... 3 Output 2 - Level [0]: Not inverted
[1]: Inverted
[2 to 3]: Reserved
— [0] All starters
155 94.0 ... 3 Output 1 signal [0]: Continuous
[1]: Flashing
[6 to 15]: Reserved
— [0] All starters
156 94.4 ... 7 Output 2 signal [0]: Continuous
[1]: Flashing
[6 to 15]: Reserved
— [0] All starters