EasyManuals Logo

Siemens SIROTEC Device Manual

Siemens SIROTEC
510 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #322 background imageLoading...
Page #322 background image
Maintenance and servicing
6.4 Replacing components
Cabinet Modules NEMA
322 Manual, 04/2014, A5E03586450A
6.4.13
Replacing the pre-charging resistors of the DC interface (option L37)
Preparatory steps
Disconnect the cabinet from the power supply (do not forget the external power supplies).
Removal
1. Remove the DC interface (see section "Replacing the DC interface")
2. Remove the fastening screws for the pre-charging resistors.
3. Remove the resistors.
Installation
1. Insert the new resistors.
2. Tighten the fastening screws of the pre-charging resistors.
3. Re-install the DC interface.

Table of Contents

Other manuals for Siemens SIROTEC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIROTEC and is the answer not in the manual?

Siemens SIROTEC Specifications

General IconGeneral
BrandSiemens
ModelSIROTEC
CategoryDC Drives
LanguageEnglish

Related product manuals