Electrical installation
4.2 Checklist for electrical installation
Cabinet Modules NEMA
64 Manual, 04/2014, A5E03586450A
Note
Touch protection
The cabinet units are provided with touch protection when the cabinet door is open
according to BGV
A3 in compliance with EN 50274.
In the version with option M60, additional protective covers are fitted. When the cabinet door
is open, these provi
de increased protection against touching live components.
These protective covers must be removed for installation and connection work, if necessary.
Once work has been completed, the protective covers must be properly refitted.
Note
Different versions
The Cabinet Modules come in a range of different frame sizes, with each size differing from
the others in several ways. The main differences are:
The covers used can have different dimensions, and they can be arranged and secured
in different ways.
The components can be arranged differently within the cabinet units.
The components can be mounted within the cabinet units using different methods.
These variations result from the different requirements made of the components/equipment
installed in the cabinet
units. These differences are intentional and exist for "EMC
Checklist for electrical installation
Use the following checklist to guide you through the electrical installation procedure for the
cabinet. Read Chapter "Basic safety instructions" before you start working on the cabinet.
For wiring instructions, see Section "Electrical installation" or refer to the documents listed in
the table below.
Note
Checking the checklist
Check the first box in the column on the right if the action applies to your cabinet unit. In the
same way, check the boxes once you have finished the installation procedure to confirm that
the activities are complete.
To Next Page
Loading...
Need help?
General