SLE SLE5000 - Controls (Via Touch Screen Display)

Page 263 of 292
28.2.3 Controls (Via touch screen display)
Adjust button: Activates alarm thresholds for modification
Alarm Auto-Track button: Sets selected %0
2
for testing
Apnea Sup Button: Sends diagnostic pulse
Apnoea setup button: Activates Backup/Apnoea settings panel
Arrow buttons: Increments value up or down or scrolls left/right
Auto set Button: Autoset high, cycle and low alarm thresholds
Backup parameter control: 1 to 150 bpm
Begin psv Button: Sends diagnostic pulse
BPM parameter control: 1 to 150 bpm
Calibrate button: Calibrates flow sensor
Calibrate Flow Sensor button: Activates calibrate flow sensor panel
CMV button: Selects CMV mode
Confirm button: Confirms selection
Continue without flow button: Selects pressure monitoring operation
Continuous HFO button: Selects oscillations in both inspiratory and
expiratory phases.
Controller button: Activates controller services panel
Compliance Trend button Selects Compliance against time display
CPAP button: Selects CPAP mode
CPAP parameter control: 0 to 20 mbar
Default button Selects the default waveform layout.
Delta P parameter control: 4 to 180 mbar
DCO
2
Trend button Selects DCO
2
against time display
End psv Button: Sends diagnostic pulse
Expiratory Only button: Selects oscillations in expiratory phase only
FiO
2
button: Selects fractional concentration of inspired
oxygen against time display
FiO
2
parameter control: 21% to 100%
Flow button: Activates flow sensor calibration panel