Page 184 of 292
17.2 Cleaning and Sterilization
Remove the flow sensor connecting cable before any cleaning, disinfection or
sterilisation.
Rinse the sensor body immediately after use and put it into a disinfectant
(recommended by the infection control authority of the hospital / organisation),
otherwise the sensor will encrust and cannot be used any more.
Warning: Do not clean the flow sensor with compressed air or water jet. As
this will destroy the sensor wires.
Flow sensor body
ET tube port
ET Manifold port
Flow sensor connecting cable
(Do Not autoclave or immerse
in liquids)
To Next Page
Loading...
