96 User Interface
2006792 Rev B – 200228
Photocell
Opens and edits the Photocell settings.
• Trigger Edge
Selects which edge of the passing product will trigger printing.
Leading: If selected, printing is triggered when the product enters the detection
area. This is the default option.
Trailing: If selected, printing is triggered when the product exits the detection
area.
• Prints per Trigger
Sets the number of times to print on a product after the photocell is triggered. The
range is 1–255. The default is 1.
• Initial Print Delay
Sets the delay time between when the Photocell is initially triggered (sees the
product) and when the printer actually prints. This number does not correspond to
any specific unit of time: it merely represents an increase or decrease in time from
trigger to print. The range is 0–59999. The default is 1000.
When finished editing Photocell settings, select Save.
Select Close to close the Photocell settings.
To Next Page
Loading...
